Dennis Baldwin - Channel
-
Wiring and Configuring a Receiver Controlled Switch with Turnigy 9X Stock Firmware and er9x
This is a demonstration of how to setup your Turnigy 9X gear switch to remotely control a Turnigy... -
DJI Naza Basic and Attitude Gain Settings for Pitch & Roll Using Turnigy 9X Control Knobs
Please check out for more discussions about multirotors. This video demonstrates the process fo... -
QAV400 Garage and Backyard Maiden Flight w/ NAZA and Turnigy 9X 3 Flight Modes
The QAV400 coupled with the DJI NAZA is simply amazing. I'm very impressed with its stability and... -
Share the Hobby with Trainer Mode (aka Buddy Box) using Turnigy 9X Transmitters
I've been wanting to learn how to set this up for a while. I expected it to be more difficult tha... -
4-in-1 Q Brain ESC Calibration on QuadLugs Frame & HK Pilot Flight Controller
Getting closer to finishing up this build. I wanted to share the process to do a 4-in-1 calibrati... -
Know Your Local & Federal UAS/Drone Guidelines
Just wanted to share my recent experience from the field. I was "grounded" by a local deputy whil... -
Pixhawk/APM Field Tips for Auto Takeoff and Landing w/ APM:Plane Firmware
I wanted to share some tips on auto takeoff and landing that I've learned over the past few month... -
FrSky Taranis 3 Flight Modes and Forced Failsafe Override with DJI NAZA on QAV400 Quadcopter
This video shows how to setup your FrSky Taranis and DJI NAZA for three flight modes on Channel 5... -
Troubleshooting Tarot T-2D Gimbal: Tips for Fixing Jitters and Shakes
This is the Tarot-2D gimbal I cover in the video: I took a severe beating from this gimbal ove... -
TuffWing 32" Flying Wing Build Video
I've wanted to purchase a flying wing for some time and came across the TuffWing, which is built ... -
DJI Naza Forced Failsafe Using Turnigy 9X Gear Switch Channel 5 Mix w/ 3 Position Switch
I posted this based on a request from several subscribers asking how to use the Turnigy 9X gear s... -
MakerBot Replicator 2 First Print Makes the Pain Go Away
I FINALLY got my MakerBot Replicator 2 up and running this eve. It's taken me 11 days, and with h...
