Painless360 - Channel
-
(2/2) PixHawk Video Series – Power, installation, final checks and first hover
To view all of the videos in this series visit – In this second video in the series we cover th... -
(1/1) PixHawk Video Series - Simple initial setup, config and calibration
Consider supporting the channel by visiting www.patreon.com/painless360 To view all of the video... -
(6/8) Naze32 Flight Controller - Adding GPS (NE-06, NEO-06 module)
In this video we configure and install a GPS module to a Naze32 board. The link to the GPS CNSS... -
(5/8) Naze32 Flight Controller - Battery monitoring (vBat) and buzzers
To watch all the videos in this series visit In this video we add and setup the buzzer and low ... -
(4/8) Naze32 Flight Controller – Adding Sonar (HC-SR04 module)
***** July 2017 - UPDATE ***** The Naze32 is now losing support from the Cleanflight and Betaflig... -
(3/8) Naze32 Flight Controller - Adding an OSD using MinimOSD
Consider supporting the channel by visiting www.patreon.com/painless360 To watch all the videos ... -
(2/8) Naze32 Flight Controller - Extra setup steps and configuration
Consider supporting the channel by visiting www.patreon.com/painless360 To watch all the videos ... -
(4/12) FrSky TARANIS Radio – Using OpenTX Companion and curves
To watch all of the videos in this series you can visit - In this video we continue on from the... -
(3/12) FrSky TARANIS Radio - Adding extra channels and controls for a Multirotor
To watch all of the videos in this series you can visit - In this video we continue on from the... -
(2/12) FrSky TARANIS Radio - Introduction to TARANIS model setup basics
Consider supporting the channel by visiting www.patreon.com/painless360 To watch all of the vide... -
(8/8) Naze32 Flight Controller - Introduction to flight modes (angle, horizon, baro mag etc)
To watch all the videos in this series visit In this video I cover the main flight modes availa... -
Turnigy R/C Switch - Use for LEDs, landing gear etc.
I have been asked by a number of my subscribers to my other video 'Adding LED lights' to go into ...
