Arduino Neural Network Robot Part 2: Soldering and Assembly

This is Part 2 of a video series where Sean Hodgins will be creating an open source Arduino based neural network robot. In Part 1 we looked at prototyping with some off the shelf components and created a custom circuit board. The board was order and is now ready to be populated with the components. Using both surface mount soldering and through hole soldering, Sean goes through the steps to assemble the robot, add a bootloader, and finally some firmware to test it. By the end of this series you will be able to create your own neural network robot using the resources provided below.
Watch Part 1 Here:
Check out Sean's Channel:
You can find the project on GitHub Here:
The circuit board on OSHPark Here:
Instrumentals Produced By Chuki
"