HPIGUY | ImmersionRC Vortex Setup - Sbus - CPPM - End Point's
During the setup on the ImmersionRC Vortex I came across a few things that no one else mentioned in a video. I thought I would show you my mistakes and how I fixed them. I could not get the OSD to appear for some reason but it turned out to be the end points on channels 1.2.3.4. A quick check and calibration through cleanflight had me up and running.
Remember to set the end points in the radio. To do this (on the trottle for example):
Power everything on
Plug into PC/Mac and run cleanflight
Click on the Receiver tab
Push the trottle up, if it does not reach 2000 then change the End point on the radio until it reaches 2000. Then put the throttle down, it should be at 1000, if it is not adjust the end point until it is.
Repeat for the YAW ELE AIL.
Download Cleanflight (in google chrome)
My Instagram:
My Facebook:
Donate to keep the channel going:
Thanks for watching.
Remember to set the end points in the radio. To do this (on the trottle for example):
Power everything on
Plug into PC/Mac and run cleanflight
Click on the Receiver tab
Push the trottle up, if it does not reach 2000 then change the End point on the radio until it reaches 2000. Then put the throttle down, it should be at 1000, if it is not adjust the end point until it is.
Repeat for the YAW ELE AIL.
Download Cleanflight (in google chrome)
My Instagram:
My Facebook:
Donate to keep the channel going:
Thanks for watching.
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.