Go Discover - Initial Range Test

Hi Go Discover fans! In this video I take you on a narrated FPV flight - on an mission to give my configuration an initial range test, and check the return to launch mode does what it should. I hope you enjoy this video, and as always please feel free to comment.
List of Equipment used in this video:
In the Air
------------
Go Discover PNF (HobbyKing)
Turnigy 3600mAh 4S 30C Lipo Pack (HobbyKing)
Quanam 12V-5A (7.2 - 25.2V) Dual Output UBEC to power video transmitter (HobbyKing)
700mw 1.2GHz video transmitter (HobbyKing)
Clear dome (HobbyKing)
GoPro Hero 3 Black edition set of 1080p 60fps Medium (Local Store)
DragonLink LRS receiver with standard diapole antenna (DragonLink)
Would appreciate the referral if you buy the DragonLink system, so I get a receiver for commission ;)
APM 2.6 controller board (ebay)
Ublox GPS and external Compass (ebay)
3DR Power module (ebay)
MinimOSD (ebay)
HobbyWing UBEC to supply 5V for flight systems (ebay)
Battery Mount and Component Tray Kit (my own design, available on ebay)
On the Ground
----------------------
2 x 1.2GHz video receivers (BEVRC)
1.2GHz Patch Antenna (BEVRC)
EagleEye from EagleTree (ebay)
Tripod (ebay)
Plastic Box to house EagleEye (ebay)
Pan and Tilt Mount (my own design and built myself - plans are available on the internet)
LCD Monitor (ebay)
FatShark Attitude SD (HobbyKing)
In my Hand
----------------
Spektrum DX8 (ebay)
DragonLink LRS Transmitter (DragonLink)
Using home made cable to connect DX8 to DragonLink (information available on internet)