Diatone Blade 150 Frame Review
This is the Diantone Blade 150 Frame. It is suppose to run 3" propellers and 3100kv or faster motors. Ideally you'd run motors around the 1104 size but they are pretty hard to find right now (and expensive). 3100kv motors should work fine as well. This frame is pretty thin compared to its larger sized brothers, but since there is overall less mass, it should be more likely to survive a crash without breaking.
One update to this video, although the side to side arms are far enough to support 4" props, the front and rear arms are too close together and the 4" props would be smashing into each other.
==========================================
Get your own! Web Links:
Diatone Blade 150 Glass Fiber Frame:
Board LEDs to solder on bottom of the frame:
Q200 Frame:
ZMR250 Frame:
One update to this video, although the side to side arms are far enough to support 4" props, the front and rear arms are too close together and the 4" props would be smashing into each other.
==========================================
Get your own! Web Links:
Diatone Blade 150 Glass Fiber Frame:
Board LEDs to solder on bottom of the frame:
Q200 Frame:
ZMR250 Frame:
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.