3D Printed FPV H-Quad Frame Widening Using Rhino 3D and Printed on MakerBot Replicator 2

I wanted to share a simple modification that I made to the 3D Printed FPV H-Quad. I'm relatively new to Rhino 3D and wanted to widen the frame width by 10mm. This video shows the process I went through to do this. I'm by no means an expert and there is probably a much easier way to do this. If you have any tips please share them in the comments below. Next up is to give the 1300mA battery a try and see what kind of flight time we get.