Discovery Buzzer on Naze32 with Taranis Setup
The buzzer connected to a Naze32 board can be configured as a discovery buzzer and assigned to a switch on the Taranis. This video gives a walkthrough on how to set it all up.
These are the high level steps that can be applied to any TX:
1. Connect a piezo buzzer into the Naze32 board
2. Setup any switch on your TX to output on channel 6.
3. In baseflight, change "beeper" to activate when the switch is turned on.
If you have an actual "Discovery Beeper" and you're not using CPPM, you should be able to connect the Discovery Beeper" to any channel on your receiver, then configure a switch on your TX to toggle that channel on and off.
Web Links:
5V Piezo Buzzer on Amazon:
-- or --
Taranis XD9 (in video):
These are the high level steps that can be applied to any TX:
1. Connect a piezo buzzer into the Naze32 board
2. Setup any switch on your TX to output on channel 6.
3. In baseflight, change "beeper" to activate when the switch is turned on.
If you have an actual "Discovery Beeper" and you're not using CPPM, you should be able to connect the Discovery Beeper" to any channel on your receiver, then configure a switch on your TX to toggle that channel on and off.
Web Links:
5V Piezo Buzzer on Amazon:
-- or --
Taranis XD9 (in video):
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.