3D Printed Flying Wing Pod
- Flying it FPV:
- Thinsverse as requested I guess:
- Bearings used both for replacing motor bearings, and for supporting the shaft at the end of the pod: ?...
- 200mm long 3mm shaft: ?...
The pod's walls are made of two 1 layer thick walls separated by 3mm and 3% infill. Or you could just say 3mm thick hollow walls.
To see what I'm up to as it happens, follow me on /
If you feel like it supporting:
?... for monthly support
has fan funding enabled on the right side of the page
Paypal email: [email protected]
Thanks to my Patreon Supporters:
Stann Sheperd
Janette
Zachary Ennenga
Jeremiah White
Joshua A.C. Newman (joined sinse last video!)
Austin Hooper
Mason Bially
MKme Lab
- Thinsverse as requested I guess:
- Bearings used both for replacing motor bearings, and for supporting the shaft at the end of the pod: ?...
- 200mm long 3mm shaft: ?...
The pod's walls are made of two 1 layer thick walls separated by 3mm and 3% infill. Or you could just say 3mm thick hollow walls.
To see what I'm up to as it happens, follow me on /
If you feel like it supporting:
?... for monthly support
has fan funding enabled on the right side of the page
Paypal email: [email protected]
Thanks to my Patreon Supporters:
Stann Sheperd
Janette
Zachary Ennenga
Jeremiah White
Joshua A.C. Newman (joined sinse last video!)
Austin Hooper
Mason Bially
MKme Lab
Fpvracer.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.