If you received the servo can not install on the rc helicopter,please follow this steps:
1.Installing swashplate servos,cut the ears;
2.Machining body,circled with a knife resection;
3.Do not cut too much time,try to put up the servos;
4.Like this one:
5.The right servo also do the step before:
7.Prefect!
7.Pay attention the front and rear steering position, keeping the vertical steering rod;
8.Below tail servo installed, this steering ears must stay, I hope you would not have been cut.Please cut circle place.
9.Started drilling holes;
10,Tighting screws;
11.Set the rudder machine, if you feel the tail is flexible you can reduce the size of the amount of control in the tail rudder machine;
12.Completion figure:
Description:
Plug: J Plugs
Cable Length: 160mm
Weight: 5.8g with the signal line, rocker, screws
Dimensions: 19.6 x 8.0 x19.4mm
Motor Type: Coreless
Gear Type: Metal
PWM signal is 50HZ, high time is 1000-2000 microseconds
Basic purposes:
1. Light remote control rc helicopter
2.EP100/200 CCPM Electric Helicopter
3.Light Remote Control Car
Package Included:
1 x servo (only)
1 x the servo arm
1 x screws
1 x manual
