Specification:
Flight controller
Brand Name: Eachine
Firmware: Betaflight_3.4.0_Crazybee
Betaflight target:
CRAZYBEEF3FR(Frsky version)
CRAZYBEEF3FS(Flysky version)
MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Board weight: 3.5 g
Power supply: 1S battery input (DC 3.5-4.35V)
Built-in 6A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Frsky receiver with telemetry(D8/D16 switchable)
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 14A
Built-in 5V 0.8A BEC with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Heading LED Ready
ESC:
Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
Current: 6A continuous peak 7A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_7.HEX
Default protocol: DSHOT600
Frsky version Receiver parameters:
SPI BUS receiver
Compatible Frsky D8 D16(NON-EU)
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitting and receiving 1 m from the ground): 300m
Flysky version Receiver parameters:
SPI BUS receiver
Protocol: AFHDS and AFHDS 2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS 2A)
No ground interference ( Transmitting and receiving 1 m from the ground): 300m
Failsafe support
Package included:
1 x Crazybee F3 Flight Controller
